Ducts, coils, fans & returns cleaned in South Melbourne ยท Free quotesFree, no-obligation quotes03 7074 1871

HVAC hygiene for South Melbourne homes and workplaces

Every part of your HVAC system, not just the vents

Ducts, coils, blower fans and returns all affect the air you breathe. We clean the full air path so your system runs cleaner and more efficiently.

  • Free quotes
  • South Melbourne & surrounds
  • Homes & businesses

Get a free HVAC cleaning quote

Let us know the system type, property size and any concerns you have noticed.

We only use your details to reply to this enquiry.

  • Free, no-obligation quotes
  • Local to South Melbourne & surrounds
  • Drop sheets & tidy work
  • Plain-English advice
Scandinavian-style living room

About us

A system-level approach to clean air

An HVAC system is a loop. Air is drawn through the return, filtered, pushed across a coil by a fan, then sent along the supply ducts to each room. Dust that gets past the filter does not stay in one place: some coats the coil, some sticks to the fan wheel and the rest lines the ductwork. Cleaning only the outlets treats the symptom. We look at the whole loop and clean each component in a sensible order.

South Melbourne has a real mix of buildings, from Victorian cottages near the market to converted warehouses, newer apartment blocks and small commercial premises along the main streets. That means we see ducted gas heating, refrigerated reverse-cycle systems and packaged rooftop units, often in the same week. Our approach stays consistent: inspect first, isolate the system, clean component by component and record what we did.

What we clean

HVAC cleaning services

Supply and return duct cleaning

We clean flexible and rigid ductwork using rotary brushes matched to the duct size, with the system held under negative pressure by a HEPA-filtered extraction unit. Both the supply runs and the return path are covered, because dirty returns quickly undo a clean supply side.

Evaporator coil cleaning

A coil clogged with dust restricts airflow and makes the unit work harder to heat or cool. Where the coil is accessible, we apply a coil-safe cleaner, rinse carefully and check the drain tray, which helps limit the damp conditions that encourage mould growth.

Blower fan cleaning

Dust caked onto the blades of a blower wheel reduces the volume of air it can move and can cause imbalance. We clean the fan wheel and housing where safe access allows, then confirm the fan runs smoothly before the system is closed up.

Filter and return grille service

We assess the filter type and condition, then clean or replace it and wash the return grille. We will also note whether the filter fits its frame properly, since gaps around the edges let unfiltered air bypass it entirely and dirty the system.

Commercial HVAC hygiene

For offices, retail and hospitality sites we clean ductwork, grilles and accessible plant, working around trading hours. We provide a written summary of the areas cleaned and any issues observed, which is useful for facility records and maintenance planning.

System inspection

Not sure what condition your ducts are in? We inspect accessible sections of ductwork and the indoor unit, looking for dust load, damage, disconnected runs and moisture. You get a plain account of what we found, so you can decide whether cleaning is needed.

Air conditioning vent and ductwork detail

Signs to look for

Indicators that your system needs attention

Weaker airflow at outlets

If outlets that once pushed air firmly now feel faint, something between the filter and the diffuser, whether coil, fan or duct, is likely restricting the flow.

Longer run times

The heating or cooling takes noticeably longer to bring rooms to temperature than it did a few seasons ago, which often points to a loaded coil or filter.

Odour on first start-up

A burnt-dust smell on the first cold day, or a damp smell on the first warm one, suggests material has collected on the heat exchanger, coil or in the ducts.

Visible build-up at returns

Fluffy grey deposits on the return grille or filter frame are usually a sign that the same material has been travelling further into the system.

Dark marks on ceilings

Shadowing around supply diffusers shows that particles are leaving the system with the airflow and depositing on surfaces immediately around each outlet.

New noise or vibration

A hum, rattle or vibration that was not there before can indicate an unbalanced blower wheel, which is sometimes caused by uneven dust deposits on the blades.

Why choose us

How we work differently

Order of operations

We clean upstream components first, then the ducts, then the outlets. Working in this order stops dust from a dirty coil or fan settling straight back into freshly cleaned ductwork.

Negative pressure throughout

The extraction unit runs for the whole clean, so loosened particles are drawn towards a HEPA filter instead of escaping into living or working areas while we brush the ducts.

Notes you can keep

After the job we summarise which components were cleaned and anything we noticed, such as torn flex duct or a poorly sealed filter, so you have a record for later.

Residential and commercial

The same disciplined method applies whether we are in a terrace with ducted gas heating or a small office running a packaged rooftop unit on a commercial strip.

Every job

Standard on every job

  • Inspection before quoting the work
  • System isolated before cleaning
  • Outlets sealed for negative pressure
  • HEPA-filtered extraction throughout
  • Components cleaned in airflow order
  • Filter assessed and frame seal checked
  • Restart and airflow verification
  • Written notes on work and findings
Technician servicing an air conditioning system near South Melbourne

How it works

Our four-stage method

  1. 1

    Inspect

    We check the indoor unit, filter, accessible ductwork and outlets to understand the system layout and how much build-up there actually is before quoting the work.

  2. 2

    Isolate

    Power to the system is switched off, outlets are sealed and the HEPA extraction unit is connected to place the ductwork under negative pressure.

  3. 3

    Clean

    Coil, fan, returns, supply ducts and diffusers are cleaned in sequence, with each section brushed and extracted before we move on to the next.

  4. 4

    Verify

    We refit components, restart the system, check airflow at the outlets and talk you through what was cleaned and anything that needs attention.

Clean the whole loop, not just the vents

Send us your system type and property details. We will reply with a free quote and a proposed scope covering the components that need it.

The difference

What a whole-system clean achieves

01

Restored airflow

A clean filter, coil, fan and duct network together remove the restrictions that build up over time, so the system can move closer to the air volume it was designed to deliver.

02

Less recirculated dust

Removing deposits from every stage of the air path means less material is released back into rooms each time the system cycles on, rather than shifting the problem downstream.

03

Fewer moisture problems

A clean coil and drain tray that drains freely reduce the damp conditions where mould and odour tend to begin, which matters in systems that cool through Melbourne's summer.

04

A clear record

You finish with notes on what was cleaned and what was found, which helps when planning maintenance, selling a property or answering questions from tenants or staff.

Service area

Service area

We cover South Melbourne and the neighbouring suburbs between the bay and the river.

  • Albert Park
  • Middle Park
  • Port Melbourne
  • Southbank
  • St Kilda
  • St Kilda West
  • South Wharf
  • Docklands
  • Melbourne
  • Windsor

FAQ

HVAC cleaning FAQs

Duct cleaning focuses on the ductwork and vents. HVAC cleaning also covers the components that move and condition the air, such as the coil, blower fan, drain tray and return section. If those parts are dirty, they keep feeding dust into the ducts, so cleaning them together gives a longer-lasting result.

It can. When dust builds up on the coil, air struggles to pass through, so the system has to run longer to reach the set temperature. Cleaning the coil and fan helps restore airflow. How much difference it makes depends on how dirty the system was and how often you use it.

Where safe access is available, yes. Many small commercial buildings in the area run packaged units on the roof. We assess access and safety requirements when quoting, and if the unit needs specialist mechanical repairs rather than cleaning, we will tell you so you can involve your HVAC technician.

It depends on use, filtration and the environment. Homes with good filters and moderate use may only need ducts cleaned every few years, while busy commercial sites benefit from more regular attention. Filters should be checked far more often. An inspection is the simplest way to set a sensible schedule.

Yes, the system is switched off while we work, both for safety and so the extraction unit can control airflow through the ducts. For a typical home this means a few hours without heating or cooling, and we restart and test the system before we leave the property.

We follow the airflow. The return grille, filter and plenum come first, then the coil and blower, then the supply ducts and finally the diffusers. Working this way stops dust released from an upstream part from settling in sections we have already cleaned, which is a common shortcoming of outlet-only cleaning.

We clean the air side of ducted gas heaters, including the return, filter, blower compartment, plenum and ducts. We do not touch the burner, gas valve or flue. Those parts should be serviced separately by a qualified gas fitter, and we will note anything we see that seems worth their attention.

Either works, but timing it before the season your system works hardest is sensible. For homes that rely mainly on ducted gas heating, late autumn makes sense. For homes that use reverse-cycle cooling heavily, spring is a good choice, especially if coil and drain tray cleaning is part of the scope.

Get in touch

Book an HVAC inspection or clean

Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.

  • Based in85 Market St, South Melbourne VIC 3205
  • Service areaSouth Melbourne and surrounding suburbs

Get a free HVAC cleaning quote

Let us know the system type, property size and any concerns you have noticed.

We only use your details to reply to this enquiry.

Need your ducts cleaned in South Melbourne?

Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.

Call nowFree quote