Service area
Service area
We cover South Melbourne and the neighbouring suburbs between the bay and the river.
- Albert Park
- Middle Park
- Port Melbourne
- Southbank
- St Kilda
- St Kilda West
- South Wharf
- Docklands
- Melbourne
- Windsor
We clean flexible and rigid ductwork using rotary brushes matched to the duct size, with the system held under negative pressure by a HEPA-filtered extraction unit. Both the supply runs and the return path are covered, because dirty returns quickly undo a clean supply side.
Ductwork is the longest part of any HVAC system and usually the least visible. In a South Melbourne terrace it might be flexible duct snaking through a cramped roof space to floor or ceiling outlets; in a converted warehouse or office it is often rigid sheet metal running above a suspended ceiling. Either way, the internal surfaces collect whatever the filter misses. Over several heating and cooling seasons, that material builds into a layer that restricts airflow and is gradually released back into occupied rooms.
We treat supply and return as two halves of the same job. Return ducts are often overlooked, yet they carry the dirtiest air in the system, straight from the rooms to the unit. Cleaning the supply side while leaving a loaded return in place means the clean ducts start collecting dust again almost immediately. So we isolate the system, seal the outlets, connect the HEPA-filtered extraction unit and work through every run, selecting brush heads to suit each duct's diameter and material.
Flexible duct and rigid duct need different handling, and we adjust our tools and technique for each. Throughout the clean, the extraction unit holds the network under negative pressure, so loosened particles move towards the filter instead of escaping through a gap. When the ducts are finished, we record which runs were cleaned, note any sections that were inaccessible or damaged, and move on to the outlets.
The return carries unfiltered room air back to the unit, so it often holds the heaviest build-up in the system. Leaving it dirty means dust keeps feeding into the filter, coil and fan, and from there back into the freshly cleaned supply ducts. Cleaning both gives a result that lasts much longer.
Yes, provided it is in reasonable condition. We use softer brush heads and controlled speeds on flexible duct to protect the inner liner. Older flex that has become brittle or torn may not tolerate cleaning, and in that case we document it and recommend replacement instead of risking further damage.
Tell us a little about your system and we will come back to you with a free quote.
How it works
We check the indoor unit, filter, accessible ductwork and outlets to understand the system layout and how much build-up there actually is before quoting the work.
Power to the system is switched off, outlets are sealed and the HEPA extraction unit is connected to place the ductwork under negative pressure.
Coil, fan, returns, supply ducts and diffusers are cleaned in sequence, with each section brushed and extracted before we move on to the next.
We refit components, restart the system, check airflow at the outlets and talk you through what was cleaned and anything that needs attention.
Service area
We cover South Melbourne and the neighbouring suburbs between the bay and the river.
Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.
