Service area
Service area
We cover South Melbourne and the neighbouring suburbs between the bay and the river.
- Albert Park
- Middle Park
- Port Melbourne
- Southbank
- St Kilda
- St Kilda West
- South Wharf
- Docklands
- Melbourne
- Windsor
Not sure what condition your ducts are in? We inspect accessible sections of ductwork and the indoor unit, looking for dust load, damage, disconnected runs and moisture. You get a plain account of what we found, so you can decide whether cleaning is needed.
Not every system needs a full clean, and not every problem is a cleaning problem. A room that never warms properly might be caused by a dirty duct, but it could also be a disconnected run, a crushed section of flex or a zone damper stuck closed. A musty smell might come from the ducts or from a drain tray that is holding water. An inspection lets us work out which components are actually contributing before anyone decides what work to do.
We follow the same path the air does. Starting at the return grille and filter, we move to the plenum, the indoor unit, and where accessible the coil, drain tray and blower. We then check a representative sample of supply ducts, using a camera to see inside runs where practical, and look at the outlets. Along the way we note dust load, moisture, damage, disconnections and any signs of poor airflow. Everything is recorded so we can explain it clearly afterwards rather than relying on memory.
You receive a plain account of what we found, component by component, along with our recommendation. That might be a full clean, a targeted clean of one or two parts, a simple filter change or nothing at all for now. Where we see a mechanical or gas issue, we say so and suggest which trade to call. You can then decide in your own time, with the facts in hand.
It tells you the condition of each accessible component, from the filter and return through to the coil, fan, ducts and outlets. You will know where dust or moisture has built up, whether there is damage, and which work, if any, we think is worthwhile. It is information first, recommendation second.
Some sections, such as ducts in a sealed ceiling or a unit boxed into a tight cavity, cannot be reached without opening up the building. We record what was not accessible and explain what that means for the inspection, so you know which parts of the picture are confirmed and which are assumed.
Tell us a little about your system and we will come back to you with a free quote.
How it works
We check the indoor unit, filter, accessible ductwork and outlets to understand the system layout and how much build-up there actually is before quoting the work.
Power to the system is switched off, outlets are sealed and the HEPA extraction unit is connected to place the ductwork under negative pressure.
Coil, fan, returns, supply ducts and diffusers are cleaned in sequence, with each section brushed and extracted before we move on to the next.
We refit components, restart the system, check airflow at the outlets and talk you through what was cleaned and anything that needs attention.
Service area
We cover South Melbourne and the neighbouring suburbs between the bay and the river.
Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.
