Service area
Service area
We cover South Melbourne and the neighbouring suburbs between the bay and the river.
- Albert Park
- Middle Park
- Port Melbourne
- Southbank
- St Kilda
- St Kilda West
- South Wharf
- Docklands
- Melbourne
- Windsor
A coil clogged with dust restricts airflow and makes the unit work harder to heat or cool. Where the coil is accessible, we apply a coil-safe cleaner, rinse carefully and check the drain tray, which helps limit the damp conditions that encourage mould growth.
The evaporator coil is where a refrigerated or reverse-cycle system actually conditions the air. Every cubic metre the fan moves passes across its thin aluminium fins, which sit very close together. When dust gets past the filter, the coil is the first thing it meets, and the fins act like a second filter that nobody ever changes. As the gaps close up, airflow drops, the system runs longer to reach its set point and the coil stays damp for longer after each cooling cycle.
Where the coil is accessible, we clean it as part of a whole-system job rather than in isolation. The system is isolated first. We then apply a coil-safe cleaner suited to the fin material, allow it to work through the build-up and rinse carefully so water ends up in the drain tray rather than in the ceiling. Fins are inspected afterwards, and any light bending we find is noted. The drain tray is cleaned and the drain line checked for flow, since standing water there is a common source of musty odours.
Because the coil sits upstream of the ducts, we clean it before the ductwork. Doing it the other way around risks washing loosened debris straight into runs we have just finished. You receive notes on the coil's condition, including anything that might need a refrigeration technician. If the coil is too heavily fouled to clean effectively in place, we say so rather than leaving it half done, and we explain the options for dealing with it.
Not always. Some indoor units give good access to the coil face, while others are packed tightly into a roof space or cabinet. We assess access during the inspection. If a coil can only be cleaned properly by dismantling the unit, we explain that and suggest involving a refrigeration technician.
No. Coil cleaning deals with the air side of the coil, meaning the fins and surfaces the air passes over. We do not open or work on the refrigerant circuit. If we notice signs that suggest a refrigerant issue, such as icing or oil staining, we note it so a technician can investigate.
Tell us a little about your system and we will come back to you with a free quote.
How it works
We check the indoor unit, filter, accessible ductwork and outlets to understand the system layout and how much build-up there actually is before quoting the work.
Power to the system is switched off, outlets are sealed and the HEPA extraction unit is connected to place the ductwork under negative pressure.
Coil, fan, returns, supply ducts and diffusers are cleaned in sequence, with each section brushed and extracted before we move on to the next.
We refit components, restart the system, check airflow at the outlets and talk you through what was cleaned and anything that needs attention.
Service area
We cover South Melbourne and the neighbouring suburbs between the bay and the river.
Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.
