Ducts, coils, fans & returns cleaned in South Melbourne ยท Free quotesFree, no-obligation quotes03 7074 1871

About South Melbourne HVAC Cleaning

Whole-system HVAC cleaning, measured and methodical

Who we are

A system-level approach to clean air

South Melbourne HVAC Cleaning exists because cleaning the vents alone rarely solves the problem. An HVAC system is a connected loop, and dust that reaches the coil or blower will keep feeding the ductwork no matter how often the outlets are wiped. So we approach every job at the system level. We look at the return, filter, coil, fan, ducts and diffusers as one path, decide which parts need cleaning, and then clean them in an order that makes sense.

Method matters in this work. We inspect before we quote, isolate before we clean and keep the system under HEPA-filtered negative pressure the whole time. Upstream components come first, the ductwork second and the outlets last, so nothing we clean is contaminated by what we clean next. At the end, we restart the system, check the airflow and write up what we did. It is a deliberate, repeatable process, and it is the same on every job.

Scandinavian-style living room
Technician servicing an air conditioning system near South Melbourne

How we work

The area we work in has an unusual range of buildings. Within a few streets of the South Melbourne Market there are single-fronted Victorian cottages, double-storey terraces, warehouse conversions, newer apartment towers and small offices above shopfronts. Heating systems range from older ducted gas units under the floor to modern reverse-cycle systems in the roof. Commercial sites add fan coil units and packaged rooftop plant. That variety keeps us adaptable, while the method stays constant.

We are clear about where our work ends. We clean the air side of the system: ducts, coils, fans, filters, returns and outlets. We do not service gas burners, repair refrigeration circuits or carry out electrical work. When we find something that belongs to another trade, such as a cracked heat exchanger panel or signs of a refrigerant problem, we document it and explain who should look at it next.

What we stand for

Our values

Upstream first

We clean components in the direction air flows, starting at the return and finishing at the outlets, so dust from one stage never undoes work already completed further along.

Evidence over assumption

Recommendations are based on what the inspection actually shows. If a component is clean enough, we leave it alone and tell you, rather than adding work by default.

Documented every time

Every job ends with notes on what was cleaned, what could not be accessed and what we observed, giving you a reliable record for future planning.

Why choose us

How we work differently

Order of operations

We clean upstream components first, then the ducts, then the outlets. Working in this order stops dust from a dirty coil or fan settling straight back into freshly cleaned ductwork.

Negative pressure throughout

The extraction unit runs for the whole clean, so loosened particles are drawn towards a HEPA filter instead of escaping into living or working areas while we brush the ducts.

Notes you can keep

After the job we summarise which components were cleaned and anything we noticed, such as torn flex duct or a poorly sealed filter, so you have a record for later.

Residential and commercial

The same disciplined method applies whether we are in a terrace with ducted gas heating or a small office running a packaged rooftop unit on a commercial strip.

How it works

Our four-stage method

  1. 1

    Inspect

    We check the indoor unit, filter, accessible ductwork and outlets to understand the system layout and how much build-up there actually is before quoting the work.

  2. 2

    Isolate

    Power to the system is switched off, outlets are sealed and the HEPA extraction unit is connected to place the ductwork under negative pressure.

  3. 3

    Clean

    Coil, fan, returns, supply ducts and diffusers are cleaned in sequence, with each section brushed and extracted before we move on to the next.

  4. 4

    Verify

    We refit components, restart the system, check airflow at the outlets and talk you through what was cleaned and anything that needs attention.

Get in touch

Book an HVAC inspection or clean

Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.

  • Based in85 Market St, South Melbourne VIC 3205
  • Service areaSouth Melbourne and surrounding suburbs

Get a free HVAC cleaning quote

Let us know the system type, property size and any concerns you have noticed.

We only use your details to reply to this enquiry.

Need your ducts cleaned in South Melbourne?

Send us the details of your system and property, and we will reply with a free quote and a suggested scope of work.

Call nowFree quote